My Quicksilver is so HOT it’s smoking!

I recently came across a new Quicksilver interface thats in development. I first came across the Fumo interface through these screenshots or mockups a while ago, but as far as I could tell they were only that, mockups. On returning to the Quicksilver forums the other day I found that not only was Fumo under development, it was getting close to completion and smoked! Intrigued I installed it and now my Quicksilver smokes!

The new Quicksilver Interface called Fumo.

What’s nice about the interface is the way it’s all in one line and the display doesn’t grow unless you set it to. I used to use Bezel but it’s movement put me off using it and when the Cube interface came out I switched over to that. It still wasn’t perfect but I was happy to use it over bezel. With the arrival of Fumo I now find myself enjoying the simplicity of an interface that doesn’t grow or move unless I tell it to!

10 Replies to “My Quicksilver is so HOT it’s smoking!”

  1. Nice!

    Good to see it’s being used. Remember, if there’s anything else you’d like to see in the interface, I’m always available.

  2. Nice!

    Good to see it’s being used. Remember, if there’s anything else you’d like to see in the interface, I’m always available.

  3. It’s certainly shaping up very nicely. If I notice anything dodgy I will pop over the QS forums and let you know. WIll you be allowing customisation of the interface rather than just the smoke? or does that work using the Bezel colouring, I’ve not actually tried!

  4. It’s certainly shaping up very nicely. If I notice anything dodgy I will pop over the QS forums and let you know. WIll you be allowing customisation of the interface rather than just the smoke? or does that work using the Bezel colouring, I’ve not actually tried!

Comments are closed.